MICRO MOLDING OPTIONS
High dosing accuracy with an ultra-repeatable process
Macro Molding
Uneven dosing volume can be adjusted by packing / holding stage.
Micro Molding
Micro Molding Challenges
Micro Molding Injection Unit
The material solidification is very quick (short fill time) so that packing / holding stage is not effective. It is easy to detect a non-fill area or flash area. In order to fill a thin-wall area, it requires a higher injection pressure, which depends on dosage volume. The machine performance is extremely important in these instances.
-
Small shot size – miniaturized parts, reduced waste (runner), residence time
-
Advanced polymers – shear sensitive, degradation factor, high temperature, high/low viscosity
-
Special polymers – implantable grade, low viscosity silicone, shape memory, bio-absorbable
-
Complex geometry – thin wall section, multiple core pulls, no conventional ejection
-
8mm Plunger / 14mm Screw – Max. Shot Size: 2.0cc (0.07oz)
-
12mm Plunger / 14mm Screw – Max. Shot Size: 4.5cc (0.15oz)
-
16mm Plunger / 18mm Screw – Max. Shot Size: 14cc (0.47oz)
Super High Response Injection Valve – Micro Series
The development of a proprietary new valve pushes the envelope in micro molding. The new linear direct double motor valve is ideal for thin wall precision molding applications.
PLUNGER
16mm
12mm
MAX SHOT SIZE
MAX INJECTION SPEED
MAX INJECTION PRESS
ACCELERATION
0.15oz
(4.5cc)
51.1"/sec
(1300mm/sec)
41730 psi
(288MPa)
15.3 G
0.47oz
(14cc)
31.5"/sec
(800mm/sec)
37962 psi
(262MPa)
12.7 G
Related Products :
Related Products :
